CCNA SECURITY LAB MANUAL VERSION 1.2 3RD EDITION PDF

.

Author:Vikasa Arabar
Country:India
Language:English (Spanish)
Genre:Technology
Published (Last):27 October 2009
Pages:322
PDF File Size:11.3 Mb
ePub File Size:6.89 Mb
ISBN:732-3-78509-869-4
Downloads:88598
Price:Free* [*Free Regsitration Required]
Uploader:Dutaur



Verify end-to-end connectivity. Because RIPv2 is a classless routing protocol, subnet masks are included in the routing updates. By default, RIPv2 automatically summarizes networks at major network boundaries.

When automatic summarization has been disabled, RIPv2 no longer summarizes networks to their classful address at boundary routers. In this lab, you will configure the network topology with RIPv2 routing, disable automatic summarization, propagate a default route, and use CLI commands to display and verify RIP routing information. Other routers, switches, and Cisco IOS versions can be used. Depending on the model and Cisco IOS version, the commands available and output produced might vary from what is shown in this lab.

Refer to the Router Interface Summary Table at the end of the lab for the correct interface identifiers. Note: Make sure that the routers and switches have been erased and have no startup configurations.

If you are unsure, contact your instructor. Instructor Note: Refer to the Instructor Lab Manual for the procedures to initialize and reload devices. Step 1: Cable the network as shown in the topology. Step 2: Initialize and reload the router and switch. Step 3: Configure basic settings for each router and switch. Disable DNS lookup. Configure device names as shown in the topology. Configure password encryption. Assign class as the privileged EXEC password.

Assign cisco as the console and vty passwords. Configure a MOTD banner to warn users that unauthorized access is prohibited. Configure logging synchronous for the console line.

Configure the IP addresses listed in the Addressing Table for all interfaces. Configure a description for each interface with an IP address. Configure the clock rate, if applicable, to the DCE serial interface. Copy the running-configuration to the startup-configuration. Step 5: Test connectivity.

At this point, the PCs are unable to ping each other. Each workstation should be able to ping the attached router. Verify and troubleshoot if necessary. The routers should be able to ping one another. After RIPv2 has been verified, you will disable automatic summarization, configure a default route, and verify end-to-end connectivity.

Step 1: Configure RIPv2 routing. Configure RIPv2 on R1 as the routing protocol and advertise the appropriate connected networks.

DURST M670 PDF

Download CCNA Security Lab Manual Version 2 (Lab Companion) PDF Free

.

BS 13453 PDF

CCNA Security Lab Manual Version 1.2 (3rd Edition) (Lab Companion)

.

GENEEN ROTH BREAKING FREE FROM EMOTIONAL EATING PDF

CCNA RSE Lab: 3.2.1.9 Configuring Basic RIPv2

.

Related Articles