Kak Subscription pricing is determined by: Zerstoerungsfreie Pruefung nach dem Eindringverfahren. Worldwide Standards We isp source any standard from anywhere in the world. Standards Subsctiption may be the perfect solution. If the document is revised or amended, you will be notified by email. Already Subscribed to this document.
|Published (Last):||27 March 2015|
|PDF File Size:||19.33 Mb|
|ePub File Size:||2.20 Mb|
|Price:||Free* [*Free Regsitration Required]|
The test can be performed on metallic multilayer plain bearings consisting of steel- or copper-based material backings lined with bearing metal based on lead and tin, with layer thicknesses greater than or equal to 0,5 mm. For cast iron backings, this document is applicable with restrictions. The ultrasonic signal reflected by the bond interface between the bearing metal and the backing is used to determine bonding defects.
Ultrasonic testing is not possible on edge zones of sliding surface, flange sides, joint areas, oil holes, grooves, etc. The same applies to bearings with dovetail keying grooves at the bond.
Ultrasonic testing of bond does not apply along the edges of the dovetails. Evaluation of the bond on the visible transition from the backing to the bearing metal on end faces or joint faces is only practicable by the penetrant testing method specified in ISO This document only describes in detail the pulse-echo method. Within the meaning of this document, the ultrasonic method only permits a qualitative evaluation of the bonding and not a quantitative determination of the bond strength.
The ultrasonic bond test differs only between bond and bond defect.
DIN ISO 4386-3:1992-11